Ignition Magic Cube 3d User Manual page 29

Slave mode
Color mode
Press [Mode] repeatedly until the display shows 'SLAv' . The device is now working in slave
mode, i.e. it will exactly copy the movement of the controlling master device, correct wiring
provided.
Press [Mode] or [Up] | [Down] repeatedly until the display shows 'Colr' . Press [Setup]. You can
now adjust the intensity of red, blue and green of the LEDs in three segments successively in a
range from 0 bis 100 %:
n Display shows 'r1.00' ... 'r1.FL' : Intensity red (0 % to 100 %), segment 1
Display shows 'g1.00' ... 'g1.FL' : Intensity green (0 % to 100 %), segment 1
n
Display shows 'b1.00' ... 'b1.FL' : Intensity green (0 % to 100 %), segment 1
n
Display shows 'r2.00' ... 'r2.FL' : Intensity red (0 % to 100 %), segment 2
n
Display shows 'g2.00' ... 'g2.FL' : Intensity green (0 % to 100 %), segment 2
n
Display shows 'b2.00' ... 'b2.FL' : Intensity green (0 % to 100 %), segment 2
n
Display shows 'r3.00' ... 'r3.FL' : Intensity red (0 % to 100 %), segment 3
n
Display shows 'g3.00' ... 'g3.FL' : Intensity green (0 % to 100 %), segment 3
n
n Display shows 'b3.00' ... 'b3.FL' : Intensity green (0 % to 100 %), segment 3
Operating
Magic Cube 3D
29
effect panel