Samsung VP-DX100H User Manual page 112

troubleshooting
PictBridge (VP-DX103( i )/DX104/DX105( i ) only)
Message Informs that...
Read Error There are some problems with file.
Ink Error There are some problems with the ink cartridge.
Paper Error There are some problems with the paper.
Print Error There are some problems with the printer.
Refer also to the user manual for the printer to be used.
When there is dew condensation, put the camcorder aside for a while before using.
• What is dew condensation?
CAUTION
Dew condensation happens when a DVD camcorder is moved to a place where there is a significant
temperature difference from the previous place. The dew condenses on the external or internal lenses of the
DVD camcorder and on the reflection lens and the surface of the disc which are related to playback. When
this happens, you temporarily may not use the record or play functions of the DVD camcorder. Also, using
the camcorder while there is condensation may cause malfunction or damage.
• What can I do?
Turn the power off and detach the battery pack, and leave it in a dry area for 1~2 hours before using it.
• When does the dew condensation occur?
When the device is relocated to a place with a higher temperature than the previous location, or when using
it in a hot area suddenly, it will cause condensation.
- When recording outside in cold weather during the winter and then using it in indoors.
- When recording outside in hot weather after being indoors or inside a car where the AC was running.
Note before sending your camcorder for repair.
• If these instructions do not solve your problem, contact your nearest Samsung authorised service centre.
• Depending on the problem, the internal memory may need to be initialised or replaced and the data will be
deleted.
Be sure to back up the data on your PC before sending your camcorder to repair.
Samsung cannot guarantee any loss of your data.
106_ English
Action
Release the protection.
• Check the ink cartridge.
• Replace the ink cartridge.
Check the paper in the printer. If there is no paper, inset
the paper.
Turn the printer power off and on.