playback
playing back a tape on the lcd Screen
•
The playback function and speaker works only in Player mode.
•
You can monitor the playback picture on the LCD screen.
1. Insert the tape you wish to view.
2. Set the Select switch to TAPE. (VP-D385( i ) only)
3. Press the MODE button to set Player (
4. Open the LCD screen.
•
Adjust the angle of the LCD screen and set the brightness or colour if necessary.
page 31
➥
5. Press the Joystick, then move the Joystick (/) left or right to rewind or forward
the tape to the starting point.
•
To stop rewinding or forwarding, move down the Joystick ().
•
The camcorder stops automatically after rewinding or forwarding is completed.
6. Press the Joystick to start playback.
•
You can view the picture you recorded on the LCD screen.
•
To stop the play operation, move down the Joystick ().
adjusting the lcd bright / lcd colour during playback
•
You can adjust the LCD bright/LCD colour during playback.
•
The adjustment method is the same procedure as used in Camera mode.
adjusting the volume
•
When you use the LCD screen for playback, you can hear recorded sound from the
built-in speaker.
- Take the following steps to lower the volume or mute the sound while playing a
tape on the camcorder.
•
When sound is heard once the tape is in play, use the Zoom(VOL) lever to adjust the
volume.
- A volume level display will appear on the LCD screen.
- Levels may be adjusted from anywhere between "00" to "19".
- If you close the LCD screen while playing, you will not hear sound from the speaker.
•
When the Audio/Video cable is connected to the camcorder, you cannot hear sound
from the built-In speaker and cannot adjust the volume.
62_ English
page 34
➥
).
page 18
➥
page 31
➥
12:00 1.JAN.2008
12:00 1.JAN.2008
MODE
CARD
TAPE
(VP-D385( i ) only)
BATT.
0:00:30:23
SP
MIX[1+2]
60min
16BIt
S
AV In
STOP
0:00:30:23
SP
60min
[11]
MOV_0001