Blackbox LGB1003A-R2 User Manual

LGB1003A-R2 Packing List:

Before you start installing LGB1003A-R2 Managed Switch, please verify that the package
contains the following items:
24-Port 1000BASE-TX L2 Plus Managed Ethernet Switch
AC Power Cord
Mounting Accessory (for 19" Rack Shelf)
User's Guide CD-ROM
RS-232 Null Modem Cable
Please notify your sales representative immediately if any of the aforementioned items is
missing or damaged.

Power Requirements :

Voltage
Frequency
Consumption

Quick Installation :

1. Install the switch in the rack with mounting accessory.
2. Connect the LGB1003A-R2 switch to an AC power source.
3. The port 1–24 connector is RJ-45 jack on the switch. Use Category 5 UTP cable to
connect between LGB1003A-R2 and end station.
4. The port 21~24 includes two types of media --- TP and SFP fiber module; they support
TP or fiber with auto-detected function.
5. Use RS-232 interface to pre-configure LGB1003A-R2 for network management.
For example: IP address, VLAN, Port Trunking, STP, etc.
LGB1003A-R2 switch's serial port default settings are listed as follows:
Baud rate
Stop bits
Data bits
Parity
Flow control
The default values of LGB1003A-R2 switch are as follows:
IP Address
Subnet Mask
Default Gateway
Username
Password
User also can use telnet or web to pre-configure LGB1003A-R2 with the default IP
address and username/password in the first configuration. Please refer to User's Guide
contained in CD-ROM for details on the setting of parameters. LGB1003A-R2 user's
manual is filed under the path: \manual of the CD-ROM.

Read Me First

AC Line
: 100∼240 VAC
: 50∼60 Hz
: 30W
115200
1
8
N
none
: 192.168.1.1
: 255.255.255.0
: 192.168.1.254
: admin
: admin