Connecting To Monitor; Connecting To Power - Samsung SDC-241 SERIES Instruction Manual

Connecting to Monitor

Connect the VIDEO Out jack to the monitor VIDEO In jack.
CCD Camera
• As a connecting method varies according to instruments, refer to
the manual supplied with the instrument.
• Connect the cable after power is turned off.
• Set the 75 /Hi-Z selection switch as shown below if you have
intermediate device.
CCD Camera
Intermediate
16
COLOR CCD CAMERA
Monitor
End monitor

Connecting to Power

Each model has different power specification, please check the name of
the model and power specification before connecting to power source.
Please refer to the sticker identifying the model, which is attached on
the product, for power specification.
AC outlet
220V
100V
AC adaptor
220V
100V
AC24V GND
AC adaptor
230V
230V~50Hz
•Be sure to connect power after all the installation is done.
NOTE
•Note that AC adaptor is not supplied with camera.
•Since the wire of DC power type is polarized, be careful when
Connecting it.
•The wire is polarized. Be sure to
connect the wire with white line on
its covering to ' - ' terminal and
connect the other one to
' + ' teminal.
•Use DC 12V power source
for SDC-311(241) ND/PD.
•Use AC 24V~50Hz power source
for SDC-311(241)PA.
(The wire is non-polarized.)
•The wire is non - polarized.
•Use AC 24V 60Hz power
source for SDC-311(241)NA.
※Connect the wire by pushing the
button
•Use AC 230V~50Hz power source for
SDC-311(241)PH.
COLOR CCD CAMERA
17