Connecting To Monitor; Connecting To Power - Samsung SIR-4260 User Manual

Installation
Adjusting varifocal lens zoom and focus
1) Unlock the zoom(or the focus) handle to release it
2) Adjust the zoom(or the focus) handle by moving it to WIDE(NEAR) or TELE (FAR) position.
3) After adjustment, tighten the zoom(or the focus) handle, taking care that the
adjusted position does not change.
Connection

Connecting to Monitor

Please connect the video output
terminal located on the back of the
camera to the monitor.
• The connection method varies
depending on the type of monitor
and accessories. Please refer to
the user's manual for each
instrument.
• Please turn off the power when
connecting.
• Please select Hi-Z on the 75Ω/Hi-Z
switch for the intermediate video
TV set and select 75Ω for the
Intermediate device as shown in
the picture below.
12
COLOR DOME CAMERA
Focus Handle
Zoom Handle
CCTV Camera Monitor
Intermediate End monitor
CCTV Camera
User's Manual

Connecting to Power

The recommended adaptor specification
for SIR-4260 is DC 12V/4A.
Please check the standard power
requirement before connecting to power.
When the resistance value of copper wire is at [20°C(68°F)]
Copper wire size(AWG) #24(0.22㎟) #22(0.33㎟)
0.078
Resistance value(Ω/m)
0.028
Voltage drop(V/m)
• As shown in the table above, voltage decreases as the wire gets longer.
Therefore use of an excessively long adaptor output line for connection to the
camera may affect the performance of the camera.
※...Standard voltage for camera operation : DC 12V±10%, AC 24V±10%
※...... T here may be some deviation in voltage drop depending on the type of wire and the
manufacturer.
Notes
• P lease must be used adaptor that meets the standard requirement.
• Please connect the power after installation.
COLOR DOME CAMERA
Connection
#20(0.52㎟) #18(0.83㎟)
0.050 0.030 0.018
0.018 0.011 0.006
13
User's Manual