Menu Setup - Samsung SDC-241 SERIES Instruction Manual

Menu Setup

Use the six Setup Menu buttons on the rear of the camera.
Menu Setup Switch
ESC FL BLC ATW VIDEO INT
OFF ON OFF AWC DC LL
Function of Menu Setup Switch
① ESC (Electronic Shutter Control)
You can turn ESC or OFF the Electronic Shutter Control feature.
This ESC mode automatically controls the shutter speed from'1/60'
to'1/100,000 ' sec (NTSC), from'1/50'to'1/100,000' sec. (PAL)
If you want to use DC or VIDEO lens, confirm this switch turn OFF.
(Electronic shutter is fixed in'1/60'sec. (NTSC) or'1/50'sec (PAL)
② FL (Flickerless)
Flickerless function. In this function, electronic shutter is fixed in
'1/100' sec(NTSC) or'1/120'sec(PAL)
FL function can compensation the flicker caused by power
frequently, but set off in the area not using a 60 Hz AC power on NTSC.
③ BLC (Backlight Compensation)
When the lighting source in the rear of object, the object might be
seen some darkness. If you want to see object clearly, turn this
switch BLC. The effective area where backlight compensation is
fixed in the center of the screen.
If you want to use DC or VIDEO lens, confirm this switch OFF.
0
0
7
13
15
18
COLOR CCD CAMERA
① Electonic Shutter speed Control : OFF
② Flickerless : OFF
③ Backlight Compensation : OFF
④ Auto White Balance : ATW
⑤ LENS Selection : VIDEO
⑥ Sync Mode : INT
(SDC-241/311 AC power only)
5 10 15
④ White balance control mode
1) ATW (Auto Tracing White balance) : The camera automatically
controls the white balance in any environment.
2) AWC (Auto White balance Control) : The White balance is automatically
adjusted in a specific environment.
•Pleace select ESC OFF that chroma mav be chance periodicallv
NOTE
because of ATW movement under the fluorescent lights indoor.
⑤ Lens selection
1) Manual Lens
Set Menu Setup switch ESC
2) Auto IRIS Lens
ⓐ VIDEO Lens : Set the ESC OFF in Menu Setup switch, and turn
DC/VIDEO selection switch VIDEO.
If you need, adjust the brightness of the screen
of the screen with adjustment VR(ALC, LEVEL) on
the VIDEO lens.
ⓑ DC Lens : Set the ESC OFF in the Menu Setup switch, and
the DC/VIDEO selection switch DC.
It may necessary to adjust the bright of the screen.
If you needs, handle the DC LEVEL the rear of the
camera.
⑥ INT/L.L (Synchronization System Mode)
Two synchronization modes are available. In L.L mode, Use V.Phase
adjust relation between the zero crossing point of AC power wave
and V─Sync Pulse of the camera's video signal.
The V.Phase has been set at 220 degrees and can be readjusted
in the range of 0 to 270 degrees as need.
L.L mode can be used in 60Hz (SDC-241/311NA).
50Hz (SDC-241/311PA/PH)
⑦ AGC (Auto Gain Control)
Always on.
COLOR CCD CAMERA 19