Name and Function of Each Part
External Control Connector
· It involves motion detection output signal.
· Zoom and Focus can be controlled by external signal.
Power LED
The LED is turned on when power is supplied.
Video Output Jack
Used to connect an external video monitor in jack.
Communication Control Connector
· It is used to connect Remote Controller.(Option)
· It involves the external trigger 'SYNC' signal input pin for line lock function.
· It involves communication pin for RS-485.
Power Input Terminal
· It involves power input. (DC12V±10%)
Connection
Connecting to Monitor
Connect the VIDEO out jack to the monitor video in jack.
CCD Camera
• As the connecting method varies with the instruments, refer to the manual
supplied with the instrument.
• Connect the cable after power is turned off.
14
COLOR CCD CAMERA
Monitor
User's Manual
• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate
device.
CCD Camera
Intermediate
Connecting to Power
Using the lead wire to connect the power supply to the Power Input Terminal as
shown in the figure below.
Frame Ground
Notes
• Be sure to connect power after the installation is done.
• The wire is polarized. Be sure to connect wires to '+' and '-' terminal.
• Use DC 12V/500mA power source for SDZ-330.
COLOR CCD CAMERA
End monitor
Power Input Terminal
15
User's Manual