GbeDigital GBE104 v2.2 Operating Manual page 2

Quick Start Guide
GBEDIGITAL model number GBE104v2.2
This page gives you basic information for setting up your digital photo frame and showing
pictures. For more detailed instructions and safety instructions, see the Operating Manual
booklet included with your digital photo frame.
Set up your digital photo frame
• Remove the protective plastic sheeting from the digital frame's LCD screen.
• Pull the plastic sheet from the remote battery terminal.
• Use the enclosed power cord (AC adaptor) to plug your digital frame into an electrical
outlet.
• Insert a media card into the appropriate slot on the side of the digital frame.
• Turn on the power switch.
• The Main menu will appear automatically.
• Using the remote control, press the PHOTO button to automatically start your slide
show. (Refer to the troubleshooting section on the Operating Manual if your slideshow
does not start up automatically.)
Wall Mount Drill Diagram
•
To mount the frame to a wall, drill two pilot holes 6.1" apart to hang the frame
horizontally, or drill two pilot holes 2.20" apart to hang frame vertically.
•
Insert screws into the pilot holes.
•
Screw them in firmly, leaving approximately 1/2" of the screw head exposed.
• Position the wall-mount slots over the screws and slide the digital frame in place.
2
6.1"
2.20"