Sharp TQ-GX30E Service Manual page 50

GX30
6. The result is displayed within a minute as follows.
When an error occurs, the corresponding message appears. Solve the problem according to "Solution".
• Error 1
Error message: "There are too many black cracks."
Cause: The light is too weak or strong.
Solution: At the proper distance from the light source (8,000 - 10,000 lux), perform black defect correction again.
• Error 2
Error message: "There are many black cracks."
Cause: The light is too weak or strong.
Solution: At the proper distance from the light source (8,000 - 10,000 lux), perform black defect correction again.
• Error 3
Error message: "There are too many black cracks cannot be rectified."
Cause: There is a hardware error.
Solution: Replace the camera unit.
4.9. ****mode release
When the handset does not turn on and enter the normal mode, use this function to change ****mode to the normal mode.
<Operation>
1) Select the COM port on the SPST initial screen and click "****mode release". The following dialog box appears.
2) If SPST cannot communicate with the handset, the following message is displayed. Make sure the handset is turned on and click "Retry". To exit,
click "Cancel".
3) When complete, the following message appears.
Downloaded from www.Manualslib.com
CONFIDENTIAL
manuals search engine
Figure 85
Figure 86
Figure 87
Figure 88
2 – 42