Sharp TQ-GX30E Service Manual page 26

GX30
4.4.3 Error message list
Below is the list of error messages for the upgrading tool (on the PC side) and Loading loader (on the handset side).
1) Error messages for the upgrading tool (on the PC side)
No.
1 Select a file for Downloading or check the box of Initializing.
2 Unable to open file.
3 You need to set the Wait Time!
4 The file you selected is unsuitable for Upgrading.
5 Cannot Setup COM port.
6 RAM Loader not responding to Commands.
7 RAM Loader responding Parameter Error.
8 RAM Loader responding Flash Error (XXXX).
9 Correspondence Error.
2) Error messages for Loading loader (on the handset side)
No.
1 FLASH_ERROR
2 ERROR_PARAM
3 ERROR_WPROTECT
4 ERROR_READ
5 ERROR_WRITE
6 ERROR_ERASE
7 ERROR_VERIFY
8 ERROR_RWE_TMOUT
9 CORRESPONDENCE_ERROR
10 ADR = XXXXXXXX
11 STR =XX
* When No.1 occurs, handset screen shows error messages for No.2 to No.8 as well as the address (No.10) and status (No.11) of the error source
at the same time.
Downloaded from www.Manualslib.com
CONFIDENTIAL
Message
Message
manuals search engine
Descriptions/Instructions
Load File is not set.
Select a MOT file.
Failed to open the MOT file.
Start over the rewrite operation.
WaitTime (S) is not set.
Set WaitTime (S) value.
The selected file cannot be rewritten for upgrading.
Select an appropriate MOT file.
The selected COM port does not exist or is used for other opera-
tions.
Select a COM port connected to the PC cable.
No response from Loading loader.
Start over the rewrite operation.
Information sent from the PC is illegal.
Reinstall the upgrading tool.
Start over the rewrite operation.
Failed to initialize FLASH ROM in (XXXX).
Start over the rewrite operation.
Undefined response from Loading loader.
Start over the rewrite operation.
Descriptions/Instructions
An error in Flash Rom.
Start over the rewrite operation.
The upgrading tool is damaged.
Uninstall and reinstall the upgrading tool, and start over the rewrite
operation.
Flash Rom is protected.
Battery may be too low.
Use a sufficiently charged battery and start over the rewrite opera-
tion.
Failed to read Flash Rom data and the operation was aborted.
Start over the rewrite operation.
Failed to write to Flash Rom and the operation was aborted.
Start over the rewrite operation.
Failed to erase Flash Rom data and the operation was aborted.
Start over the rewrite operation.
The rewrite operation was aborted since there was a mismatch
between data written to Flash Rom and that written to handset.
Start over the rewrite operation.
Communication was terminated since there was no response from
Flash Rom for a certain period of time.
Start over the rewrite operation.
Communication was terminated since serial data communication
failed.
Start over the rewrite operation.
Indicates the address of Flash (the error source).
Indicates the status of Flash (the error source).
2 – 18