Advertisement
playback
PLAYING BACK A TAPE ON ThE LCD SCREEN
•
The playback function and speaker works only in Player mode. ➥page 18
•
You can monitor the playback picture on the LCD screen.
You can monitor the playback picture on the LCD screen.
1. Insert the tape you wish to view. ➥page 34
2. Set the Select switch to TAPE. (SC-D383/D385 only)
3. Press the MODE button to set Player (
4. Open the LCD screen.
•
Adjust the angle of the LCD screen and set the
brightness or color if necessary.➥page 31
5. Press the Joystick, then move the Joystick (/) left
or right to rewind or forward the tape to the starting point.
to rewind or forward the tape to the starting point.
•
To stop rewinding or forwarding, move down the
Joystick ().
•
The camcorder stops automatically after rewinding or
The camcorder stops automatically after rewinding or
forwarding is completed.
6. Press the Joystick to start playback.
•
You can view the picture you recorded on the LCD
screen.
•
To stop the play operation, move down the Joystick ().
Adjusting the LCD Bright / LCD Color
during Playback
•
You can adjust the LCD bright/LCD color during
playback.
•
The adjustment method is the same procedure as
used in Camera mode. ➥page 31
Adjusting the Volume
•
When you use the LCD screen for playback, you can
hear recorded sound from the built-in speaker.
- Take the following steps to lower the volume or mute
- Take the following steps to lower the volume or mute
the sound while playing a tape on the camcorder.
•
When sound is heard once the tape is in play, use
the Zoom(VOL) lever to adjust the volume.
-
A volume level display will appear on the LCD screen.
A volume level display will appear on the LCD screen.
-
Levels may be adjusted from anywhere between
"00" to "19".
- If you close the LCD screen while playing, you
will not hear sound from the speaker.
•
When the Audio/Video cable is connected to the
camcorder, you cannot hear sound from the built-In
speaker and cannot adjust the volume.
62_ English
播放
在 LCD 螢幕上播放錄影帶
•
•
CARD
TAPE
).
(SC-D383/D385 only)
).
SP
MIX[1+2]
12:00 1.JAN.2008
STOP
SP
[11]
12:00 1.JAN.2008
播放功能和喇叭僅可在 Player 模式下操作。 ➥ 第 18 頁
您可以在 LCD
您可以在 LCD 螢幕上監視播放畫面。
1.
1. 放入您要檢視的錄影帶。 ➥ 第 34 頁
2. 將選擇開關設定為 TAPE。 （僅適用於 SC-D383/
2.
MODE
D385）
3. 按下 MODE 按鈕以設定 Player (
3.
4. 打開 LCD 螢幕。
4.
•
調整 LCD 螢幕的角度、如有必要、設定亮度或
➥
色彩。
第 31 頁
BATT.
5. 按下 Joystick、 然後向左或向左移動 Joystick (/)
5.
以將錄影帶回轉或前進至起始點。
•
以將錄影帶回轉或前進至起始點 Joystick
•
完成回轉或前進後、攝錄放影機會自動停止。
6. 按下 Joystick 以開始播放。
6.
•
您可以在 LCD 螢幕上檢視您所錄製的畫面。
•
若要停止播放操作、可向下移動 Joystick
在播放期間調整 LCD Bright / LCD Color。
在播放期間調整
•
您可以在播放期間調整 LCD bright/LCD 色彩。
•
調整方法和在 Camera 模式中使用的程序相同。
➥ 第 31 頁
0:00:30:23
60min
調整音量
調整音量
16BIt
S
•
當您使用 LCD 螢幕來播放時、您可以從內置喇叭
聽到所錄製的音效。
- 在攝錄放影機上播放錄影帶時採取以下步驟來
AV In
調低音量或設定靜音。
•
當您聽到錄影帶播放的音效時、使用縮放
(VOL) 桿來調整音量。
- LCD 螢幕上會出現音量顯示。
0:00:30:23
- 音量可在 "00" 到 "19" 之間進行調整。
60min
- 若您在進行播放時關閉 LCD 螢幕、您將不
會從喇叭聽到音效。
•
當聲訊 / 視訊纜線連接到攝錄放影機時、您將無法
從內置喇叭聽到音效、同時也不能調整音量。
MOV_0001
).
()
。
()
。
臺灣 _62
Advertisement
Chapters
