Dolphin 12V25A Technical Manual

Dolphin 12V25A Technical Manual

All-in-one-premium. power unit dc & ac
Hide thumbs Also See for 12V25A:

Advertisement

TECHNICAL MANUAL
Power unit
DC & AC
12V25A
Code : 399121
12V40A
Code : 399123
EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 12V25A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dolphin 12V25A

  • Page 1 TECHNICAL MANUAL Power unit DC & AC 12V25A Code : 399121 12V40A Code : 399123...
  • Page 2: Safety Precautions

    SAFETY PRECAUTIONS NOT_AIO.PREMIUM-01 NOT_AIO.PREMIUM-01 TO PREVENT ANY RISK OF ELECTRIC SHOCK 4It is strongly recommended that the unit be OR FIRE, READ THIS MANUAL CAREFULLY mounted vertically, with the cable exit at the BEFORE INSTALLING THE EQUIPMENT. bottom. 4The mains power socket and the battery In the event of a problem, or something you do connector must remain accessible and workable not understand, contact KREPEL.
  • Page 3 SAFETY PRECAUTIONS NOT_AIO.PREMIUM-01 NOT_AIO.PREMIUM-01 Mains power cable length must not exceed 3 Unit serial No. metres, and 1.5 metres for the battery cables. The unit serial number is on the grey label, bonded Ensure that the AC and DC cables are properly to one of the case side panels.
  • Page 4: Technical Specifications

    4Battery fuses should only be replaced by fuses of Boost = 15,4V Float = 13,8V identical specification and ratings. scanning charge Boost.1 = 14,8V Spiral cell agm Boost.2 = 15,5V Float = 13,8V 12V25A 12V40A Boost = 14,4V Code 399121 399123 Winterizing Weekly automatic Float = 13,2V...
  • Page 5: Operating Modes

    OPERATING MODES CONNECTIONS NOT_AIO.PREMIUM-01 NOT_AIO.PREMIUM-01 Circuit diagram Main connector Main breaker Battery connector LED1 LED2 +DC3 AC/DC +DC2 Battery +DC1 charger LED.1 STATUS MODE Batteries are being charged. Yellow Charging phase time varies up to 6 steady Charging hours, depending on the battery’s initial charge level.
  • Page 6 CONNECTIONS DIMENSIONS NOT_AIO.PREMIUM-01 NOT_AIO.PREMIUM-01 Installation dimensions Charge selector Battery fuses Assembly of Winsta AC connectors 7 STEP 1 Strip the cable over around 3 cm Strip the 3 wires over around 8 mm Tin the bare copper ends 7 STEP 2 Remove the cap from the case, using a cutter 7 STEP 3 Thread the cable into the case...
  • Page 7: Warranty

    WARRANTY WARRANTY NOT_AIO.PREMIUM-01 NOT_AIO.PREMIUM-01 IN ORDER TO ENSURE THAT THE UNIT IS PROPERLY Important: Note concerning the charging rate. USED, CAREFULLY READ THE LIST OF INCIDENTS OR POTENTIAL DEFECTS NOT COVERED BY THE Using a charging cycle that is unsuitable for the WARRANTY battery technology may seriously damage the battery.
  • Page 8 4Dolphin products under normal use (when used within the If there is no local distributor, dealer or DOLPHIN relevant specifications) for a period of two years after purchase from the DOLPHIN dealer with office in your area, then please contact DOLPHIN France.
  • Page 9 For further information, contact: KREPEL LTD. 9000, Varna, Bulgaria Tel: +359 52 785 870 Fax: +359 52 785 890 e-mail: office@krepel.bg www.krepel.bg...

This manual is also suitable for:

12v40a

Table of Contents