Programming - Weathermatic PROLINE PL800 Owner's Manual

www.weathermatic.com
occur. The Language Selection LED will display red when
controller is turned to SYSTEM OFF.
If you move the dial to any position other than RUN or
SYSTEM OFF, and there is no control panel activity for 30
minutes; the controller will return to the RUN mode, and
the display screen will show the idle default screen or will
return to a program in progress that was interrupted.
Language Button: Press Language button to select English
or Spanish for programming the controller. During
normal operation the Language LED will display GREEN.
It will change to ORANGE during a pause in operation
and will display RED when ProLine™ controller dial is
turned to SYSTEM OFF.
Sensor Button: Used to activate or bypass optional
sensors for rain, freeze, or wind. If these sensors are
connected to your
ProLine™ controller, they
will override watering
operations if the ACTIVE
LED is selected. If your
sensor/s have paused
your system operation,
the ACTIVE LED will be
RED until the sensors
allow watering to resume. The sensor LED will display
GREEN again when the sensor/s are no longer pausing
your system operation.
If you wish to deactivate the sensors, use the SENSOR
button to light the green BYPASS LED. Example: You wish
Getting acquainted with your ProLine™ Controller 2.0
to water after fertilizing and your rain sensor is still pausing
the watering program. As long as the BYPASS LED is on,
the sensors will not pause your system operation.
Note: If you have zones you want to omit from sensor
shutdown, see Sensor Operation later in this manual.

2.2 Programming

Using the Programming Buttons
A FLASHING DISPLAY indicates that user choices are
available. The  and  Adjust Value buttons are used to
scroll through numeric values or to make a choice of menu
options.
NEXT and BACK Buttons: When watering zones are being
programmed, the left side of the display will indicate the
zone number. The NEXT and BACK buttons are used to
scroll through the zones. If the flashing display indicates
Note: The
a menu selection rather than a numeric value, the NEXT
SENSOR button
button will open the menu for further programming. The
can be used to
BACK button will exit the menu and cause the chosen value
bypass rain and
to be saved in memory.
freeze sensors.
RAPID ADVANCE: While programming, holding down the
 or  arrow button will cause the flashing display value
to rapidly advance. Rapid advance can also be used with
the NEXT and BACK buttons to rapidly advance through
zones.
MENUS WITHIN MENUS: In cases where there are menus
within menus, each press of the BACK button will return
4