System Mode - Century Hawk 4 User Manual

System Mode

In the System Mode the printer's buttons allow for the performance
of Reset, Media Sensor Calibration and Self-testing. The printer
cannot receive commands from the host when in the System Mode.
- Entering: Press and hold the CANCEL button for 4 seconds, the three
blinking lamps indicate the printer is in System Mode. The LCD will
display SYSTEM MODE on Hawk 4S printers.
- Exiting: The printer will exit the System Mode automatically if no
operations are performed within 4 seconds of entering into the System
Mode.
Reset – Reset the Printer to the Factory Default Settings
Following the steps listed below allows you to reset the printer to the
factory default settings.
1. After entering System Mode, press the CANCEL button.
2. The three indicators stop blinking and remain lit. The printer is now in
its normal state.
The following parameters have automatically been reset:
- Label
- Print darkness
- Speed
- Others
Note：The printed label count and printed length may not be reset.
Media Sensor Calibration
It is necessary to perform a Media Sensor Calibration after a new roll of
media has been loaded.
1. After entering System Mode, press the FEED button.
2. The three indicators continue blinking.
28