Connecting The Printer; Power Connection; Interface Connection - Century Hawk 4 User Manual

Connecting the Printer

Power Connection

Caution:(1) Use of the wrong adapter could damage your printer.
Century Systems assumes no liability for any damage in
such case. The rating for the printer is 24VDC.
(2) Do not use the printer near liquids or corrosive chemicals.
1. Make sure the printer is switched OFF.
2. Connect the power cord to the Power Adapter.
3. Connect the Power Adapter's DC output plug to the DC IN port on the
back of the printer.
4. Plug the power cord into a live wall outlet.

Interface Connection

Caution: Make sure the printer is switched OFF before connecting the
interface cable.
The interface between the printer and the host will use either a serial or
USB（or parallel）cable. Contact your reseller for Ethernet connection
options.
1. The printer identifies the communication port automatically.
2. The default values of printer port can be obtained from the self-test
report. (See Chapter 2 Operation Basics - System Mode - Self Test)
3. Cable configurations for serial (RS-232C) and parallel
(Centronics) interfaces are shown in Appendix A of this guide.
10