Replacing Module Inserts; Special Modules - JUMO mTRON T Installation Instructions Manual

Measuring, control, and automation system router module

Hide thumbs Also See for mTRON T:

Table of Contents

2 Mounting

2.3

Replacing module inserts

2.3.1

Replacing the module insert of a router module 705040

For service purposes, the case (D) can remain in the system; only the module insert (B) is re-

placed. Thanks to the hot connect functionality of the router module, this can even be per-

formed during operation with the corresponding configuration (alias device address).

The new module insert also has a new nameplate (F), which differs from the old one at least

with regard to the fabrication number and is no longer identical to nameplates (E) and (C) on

the case (D).

Therefore, in the event of replacement, the module insert will be supplied along with a new

nameplate that will be affixed to the case (D) in place of the old nameplate (C). This means that

the specifications of nameplates (F) and (C) once again correspond to one another.

Removing the module insert

Step

(A)

(B)

Activity

Pull off the connection cables if required (Bus In, Bus Out1, Bus Out2).

Pull off the wired terminal strip (A) toward the front.

Press the old module insert (B) together on the grooved surfaces at the top and bottom and

remove from the case (D).

(F)

(C)

(D)

(E)

Table of Contents