Special Modules - JUMO mTRON T Installation Instructions Manual

Measuring, control, and automation system router module

Hide thumbs Also See for mTRON T:

Table of Contents

NOTE!

Two rotary coding switches for setting the alias device address are located on the router mod-

ule's left side. If necessary, the setting should be done before the router module is mounted.

Otherwise one has to ensure that the rotary coding switches are still accessible after mount-

ing.

The "10x" switch is used to set the tens digit of the alias device address, the "1x" switch is

used for the unit digit. For more information about setting the alias device address please re-

fer to the setup program manual B 705000.6 (chapter "Hardware arrangement").

2.2.1

Special modules

Installation, using the example of a router module 705040

Procedure:

Step

(A)

Activity

Mount the router module (A) in the DIN rail from above (A1).

Pivot the router module (A) downward until it snaps into place (A2).

Position the end bracket (B) on the DIN rail and move to the right against the router module

(B3).

Fasten the end bracket (B) using a screwdriver (B4). For this purpose, ensure that the end

bracket is positioned flush against the router module.

(A1)

(A2)

2 Mounting

(B)

(A)

(B3)

(B4)

Table of Contents