Medeli DD506 Assembly Instructions

ASSEMBLY INSTRUCTIONS
Caution !
Watch your fingers when adjusting clamps. They may become pinched resulting in injury.
Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers.
Inside This Package
Before assembly, please make sure that all the items listed below are present.
[CYMBAL 3PCS] box [BASS DRUM PEDAL] box
Assembly
1 Setting up the frame of the d igital drum set
[1] Attach the Pillar (L) to the clamp on the L eg (L).
[2] Using the drum key, tighten the screws on the clamp.
[3] Remove the screw att ached to the connector.
[4] Attach the cross pipe to the connector.
[5] Reattach the screw int o the connector
[6] Tighten the screw on the connector.
[7] Attach the Pillar (R) to the clamp on the Leg (R).
[8] Tighten the screws on the clamp.
[9] Remove the screw att ached to the connector.
[10] Attach the cross pipe to the connector.
[11] Reattach the screw into the connector
[12] Tighten the screw on the connector.
[13] Attach Center Pipe(1) to the clamp on the Left Leg Assembly.
[14] Tighten the screws on the clamp.
[15] Attach the Right Leg Assembly to the Center Pipe(1) .
[16] Tighten the screws on the clamp.
[17] Attach Center Pipe(2) to the clamp on the Left Leg Assembly.
[18] Tighten the screws on the clamp.
[19] Attach the Right Leg Assembly to the Center Pipe(2) .
[20] Tighten the screws on the clamp.
[21] Attach the Side Arm (L1) to the clamp on the Pillar (L) .
[22] Tighten the screws on the clamp.
[23] Attach the Side Arm (L2) to the clamp on the Pillar (L).
[24] Tighten the screws on the clamp.
[25] Attach the Side Arm (R) to the clamp on the Pillar (R)
[26] Tighten the screws on the clamp.