NIPRO Diagnostics True Metrix Pro Manual page 23

Set Event Tags, Ketone Alert and
Test Reminders
Meter comes with Event Tags, Ketone Test
Alert and all Test Reminders turned off.
Note: If the meter turned off at any time
during Set Up, go back to Step #1 under
Meter Set Up and begin again.
Event Tags
Event Tags are used to mark a test result
that was taken during a specific event.
1. After setting the year, press " " or " "
Button to turn Event Tags on or off.
Press " • " Button to set. The meter
goes to set Ketone Test Alert.
Event Tags may be used after each blood
glucose result. Event Tags are as follows:
Before meal –test was taken just
before a meal,
After meal – test was taken 2 hours
after the start of a meal,
Exercise – test was taken during or
after exercise,
Medications – medication taken may
have affected test result,
Sick – test was taken when sick,
Other – any other reason that the test
is unique or different in some way
(example: stress, drinking alcohol).
Ketone Test Alert
When a blood glucose result is over
240 mg/dL, the Ketone Test Alert is a
reminder to check the patient's ketones
per the treatment plan prescribed by
the doctor or diabetes healthcare
professional.
2. Press " " or " " Button to turn
Alert on or off. Press " • " Button
to set. Meter goes to set
Test Reminder.
TRUE METRIX PRO System Comprehensive Resource Guide (GDH-FAD Enzyme)
®
Meter Setup
When a Ketone Test Alert is shown in
the meter display, it does not mean
that ketones have been detected
in the patient's blood. Perform a
ketone test per the treatment plan,
as prescribed by their Doctor or
Diabetes Healthcare Professional.
Test Reminder
Up to four Test Reminders per day may
be set. Reminder sounds at set time for
10 seconds. Meter comes with all Test
Reminders off. To set the Test Reminders:
1. After pressing " • " Button to set Ketone
Test Alert, Display shows first Reminder
setting (A-1). To turn Reminder on, press
" " Button. Press " " Button to turn
Reminder back to off. Press " • " Button to
set. Meter goes to next Test Reminder.
2. When "on" is chosen, press " • " Button.
The hour flashes. Press " " or " " Button
to set the hour. To set AM/PM, scroll (press
" " or " " Button) until "AM" or "PM" is
next to correct time. Press " • " Button
to set.
3. The minutes flash. Press " " or " "
Button to set the minutes. Press " • "
Button to set. Meter goes to the next
Test Reminder.
4. Turn Reminders on and repeat setting the
time for next 3 Reminders (if needed).
Exit Setup
Press and hold " • " Button until meter turns
off. Meter also turns off after 2 minutes of
non use. Set-up choices are saved.
Note: If Test Reminders are set, the Alert
Symbol appears in all Displays. If battery
dies or is replaced, Ketone Test Alert and
Test Reminders may have to be reset.
cont.
Test Reminder
Meter Setup 17