Meter Setup - NIPRO Diagnostics True Metrix Pro Manual

Meter Setup is to be used if changes need
to be made to the time and date, Event Tags,
Ketone Test Alert, or if settings need to be
reset because of battery change.
Note: Setting up the time, date, Event Tags,
Ketone Test Alert and Test Reminders
may not be suitable for a multiple-
patient use of the system. Check with
the facility procedures and policies
before performing Set Up.
Note: If the meter turns off at any time during
Set Up, go back to Step #1 under Meter
Set Up and begin again.
TRUE METRIX PRO System Comprehensive Resource Guide (GDH-FAD Enzyme)
®

Meter Setup

1. Press and hold "•" Button until the full display is
shown and a tone sounds (around 10 seconds).
Release "•" Button. Meter goes into Set Up.
Set Up of Time and Date
2. The hour flashes. To change, press " " or " "
Button on top of the meter to select the hour. Like
many alarm clocks, to set "AM" or "PM", scroll
through the hours until "AM" or "PM" appears in
the Display. Press " • " Button to set.
3. The minutes flash. To change, press " " or " "
Button to select the minutes. Press " • " Button
to set.
4. The month (number) flashes. To change, press
" " or " " Button to select the month. Press " • "
Button to set.
5. The day (number) flashes. To change, press " "
or " " Button to select the day. Press " • " Button
to set.
6. The year flashes. To change, press " " or " "
Button to select the year. Press " • " Button to set.
Note: Meter beeps every time a setting is confirmed
(" • " Button is pressed).
Meter Setup 16