Table of Contents
Advertisement
18
5. You may want to test the email notification you've just setup, by clicking Test next to the notification. Make sure
you Write your changes under Device Access before attempting a test. You will prompted with a pop up. Click
OK to send a test SNMP alarm notification. Confirm all your settings by checking your alarm master to see if the
SNMP trap was received.
NOTE: This test only means that your notification settings are correct, but you still need to assign the notification
to an alarm point. See the next step.
6. Now you will associate this notification to a system alarm. You have 8 notification devices available to use. In
the image below, you might assign Notification Device 1 to System Alarm 49. This means that you would
receive an email notification when an alarm for System Alarm 49 (NTP failed) occurs.
Advertisement
Table of Contents
Need help?
Do you have a question about the Site Dialer G3 and is the answer not in the manual?
Questions and answers