TP-Link Archer C2600 User Manual page 78

Chapter 12
How can
I do that?
1. Change the routers' LAN IP addresses to two different IP
addresses on the same subnet. Disable Router B's DHCP
function.
2. Visit http://tplinkwifi.net, and log in with the username and
password you set for Router A.
3. Go to Network > Advanced
4. Click
Add and finish the settings according to the following
explanations:
Network Destination:
to assign to a static route. This IP address cannot be on the same
subnet with the WAN IP or LAN IP of Router A. In the example,
the IP address of the company network is the destination IP
address, so here enter 172.30.30.1.
Subnet Mask: Determines the destination network with the
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
the corresponding network IP. In the example, the destination
network is a single IP, so here enter 255.255.255.255.
Default Gateway: The IP address of the gateway device to which
the data packets will be sent. This IP address must be on the
same subnet with the router's IP which sends out data. In the
example, the data packets will be sent to the LAN port of Router
B and then to the Server, so the default gateway should be
192.168.0.2.
Customize Your Network Settings
Routing.
The destination IP address that you want
74