Table of Contents
Advertisement
0-Chapter 4-1(GODREJ)
4
T
HE
Receiving in TAD Mode
1
Press RCV. Mode
repeatedly until ÔTADÕ is
displayed.
In Standby Mode, TAD
appears in the right side
of the display.
2
When a call comes in, the
answering machine
answers and stores the
callerÕs message if they
leave one.
If the machine detects a
fax signal, it goes into
receive mode.
Notes:
¥ If you have set your machine to TAD and your answering machine is switched off, or the answering
machine is not connected to your fax machine, the machine will automatically go into receive mode
after several rings.
¥ If your answering machine has a Ôuser-selectable ring counterÕ, set the machine to answer an
incoming call within 4 rings or less.
¥ If the sound level of the call is too low because of a poor phone connection, the fax machine or
answering machine may not work properly.
¥ When you are using manual reception mode on your machine, and you have an answering machine,
you must make sure you switch off the answering machine, or the outgoing message will interrupt
your phone conversation.
¥ Not all answering machines may work with your fax machine.
¥ When your answering machine answers an incoming call, it record a fax tone until it realises it is a
fax coming through. Your answering machine may tell you a voice message has been left, when it is
actually a fax.
4.10
C
F
T
HAPTER
OUR :
9/20/98 5:13 PM
Page 2
F
M
AX
ACHINE
2 0 - J U N 1 0 : 3 0 T A D
F
M
HE
AX
ACHINE
(SF3000)
Rcv.
Mode
Redial/
Pause
Advertisement
Table of Contents
