Programming The Device - Carel supernode Technical Leaflet

Electronic controller for humidifi cation

Hide thumbs Also See for supernode:

ENG

3. PROGRAMMING THE DEVICE

Set the number of devices connected to the gateway:

values available: from 1 to 20 devices.

Menu path: Service  Service Settings  Device settings

Set the address and type of device :

Models available: heaterSteam, humiSteam X-plus, humiSteam basic,

gaSteam, generic device

Menu path: Service  Service Settings  Device settings

The address setting and type of model must be selected for each

device connected to the gateway

Set the BMS1 and BMS2 serial port for reading by external

supervisor:

Address, protocol and baud rate setting.

Menu path: Service  BMS Settings

Set the Carel master protocol for communication between

Supernode and devices:

Supernode communication protocol setting with devices: baud rate

(Retry n. and ORT can be left as default)

Note: the baud rate to be set always corresponds to the slowest

device connected (for heaterSteam the baud rate is 9600).

Menu path: Manufacturer  Factory Settings

+050003325 Supernode for humidiﬁ cation - 1.0 - 20.06.2014