Table of Contents
Advertisement
The iPhone or iPad is connected to the camera.
4.
Confirm that your iPhone or iPad was connected to the "SSID" shown on the camera.
5.
Set the camera to shooting mode.
6.
Return to the "Home" screen of the iPhone or iPad and launch PlayMemories Mobile.
Hint
Once the QR Code has been read, the camera's SSID (DIRECT-xxxx) and password are registered to the iPhone or iPad. This
enables you to easily connect the iPhone or iPad to the product via Wi-Fi at a later date by selecting the SSID.
Note
This product shares the connection information for [Ctrl w/ Smartphone] with a device that has permission to connect. If you want
to change the device that is permitted to connect to the product, reset the connection information by following these steps. MENU
→
(Network) → [Wi-Fi Settings] → [SSID/PW Reset]. After resetting the connection information, you must register the iPhone
or iPad again.
If you have performed [SSID/PW Reset] or [Edit Device Name] on the camera, you will be unable to establish a Wi-Fi connection
by scanning a previously scanned QR Code. In this case, display a new QR Code by selecting [
it.
When [Airplane Mode] is set to [On], you cannot connect this product and the iPhone or iPad. Set [Airplane Mode] to [Off].
Live-view images may not be displayed smoothly on the screen of the smartphone depending on the surrounding radio-wave
conditions and the performance of the iPhone or iPad.
207
Connection Info.] and rescan
Advertisement
Table of Contents
