Troubleshooting/Maintenance - Amprobe CR50A User Manual

TROUBLESHOOTING/MAINTENANCE

If there appears to be a malfunction during
the operation of the meter, the following steps
should be performed in order to isolate the
cause of the problem:
1. Check the battery.
2. Review the operating instructions for
possible mistakes in operating procedure.
3. Inspect and test the Test Probes for a
broken or intermittent connection.
4. Inspect and test the fuse. See Fuse
Replacement.
Except for the replacement of the battery or fuse,
repair of the multimeter should be performed
only by a Factory Authorized Service Center or by
other qualified instrument service personnel.
The front panel and case can be cleaned with
a mild solution of detergent and water. Apply
sparingly with a soft cloth and allow to dry
completely before using. Do not use aromatic
hydrocarbons or chlorinated solvents for cleaning.
Battery/Fuse Replacement
X� WARNING
To prevent electrical shock hazard, turn off
the multimeter and any device or circuit under
test and disconnect the test leads before
removing the rear cover.
12