Chapter 4. Initial Setup And Programming; Introduction - GE AquaTrans AT600 User Manual

Chapter 4. Initial Setup and Programming

4.1 Introduction

This chapter provides instructions for programming the AT600 flow meter to place it into service. Before the
AT600 can begin taking measurements, at least the following menus must be programmed:
•
"User Preferences" on page 43
•
"Inputs/Outputs" on page 48
•
"Sensor Setup" on page 66
Refer to the Main Menu map in Figure 30 below, and proceed to the appropriate section for instructions.
Display
Main Menu
Display Format
User Preferences
Save Changes?
Yes
No
Display
AquaTrans™ AT600 User's Manual
Program Program Review
Password
xxxx
Input/Output
Sensor Setup
Figure 30: Main Menu Map
Chapter 4. Initial Setup and Programming
Keypad Lockout
Calibration Advanced
Language
Factory
31