Privacy Masking Settings - LG LPT-EP551PS Owner's Manual

LPT-EP500_ENG 12/24/07

Privacy Masking Settings

Using the LCC-K1000 or controller with Multix
protocol for Privacy Zone Setting.
This function is aiming at the protection of personal
privacy, selecting a screen part black not to be
displayed in the screen.
Up to 8 zones can be registered. Submenus are
provided for zone number selection and parameter
setting.
To register a new privacy zone using the
LCC-K1000
1. Press the Set Up button then select the
[PRIVACY ZONE] icon.
2. Press SEL.
The sub menu will appear for [PRIVACY ZONE]
setting.
3. Select [Set Zone Area] option then press SEL.
The sub menu will appear.
4. Use number buttons to select the zone index
number then press SEL to confirm.
The blue zone frame appears on the center of
monitor.
1:34 PM Page 31
5. Adjust the pan, tilt, and zoom position so that the
desired position comes into the zone frame with
the joystick.
You can't move privacy mask zone and you can't
change the size of privacy mask zone.
6. Press SEL.
The mask color will be change into grey.
The privacy zone setting has been completed and
the setting is memorized in the camera's memory.
7. Repeat steps 3-6 to add additional position.
To register a new privacy zone using the
other controller with Multix protocol
You must use the LCC-K1000 controller to set the
privacy mask zone. If you use the other controller or
unit with Multix Protocol, refer to follow steps.
1. Use the command below to display the blue zone
frame on the center of monitor to set the privacy
mask zone.
Guide Code 0x01 Dome ID 0x81
(0xE5)
2. Adjust the pan, tilt and zoom position so that the
desired position comes into the zone frame.
3. Use the command below to confirm the privacy
mask setting.
Guide Code 0x01 Dome ID 0x81
(0xE5)
4. The mask color will be changed into gray if the
privacy zone settings are completed. The settings
are memorized in the camera's memory.
Notes:
• The Check sum is calculated by performing the
8bit sum of the all bytes except check sum.
• The P MASKING menu option of the camera is
used for factory control. If you set the privacy
mask zone using the P MASKING menu option of
the camera, the privacy mask function may cause
a malfunction.
• Please contact authorized service center or where
you purchased to know the all of the protocol.
0x01 Index of 0x00 Check
Mask sum
0x02 Index of 0x00 Check
Mask sum
31