Install The Ac Power Cables; Activate An Ac Power Supply Module - Cisco NCS 540 Hardware Installation Manual
Hide thumbs
Also See for NCS 540:
- Configuration manual (72 pages) ,
- Command reference manual (84 pages) ,
- Configuration manual (19 pages)
Table of Contents
Advertisement
Install the AC Power Cables
Install the AC Power Cables
To install the AC power cables in the power supply slots:
Step 1
Plug the power supply cord in the power supply module.
Step 2
Insert the power supply cord into the tie [1] and tighten the tie around the power supply cord as shown in [2] in the figure
below.
Figure 7: Attach the AC Power Tie-and-Clip Cord
Activate an AC Power Supply Module
Perform the following procedure to activate an AC power supply:
Step 1
Plug the power cord into the power supply.
Step 2
Connect the other end of the power cord to an AC-input power source.
Cisco NCS 540 Router Hardware Installation Guide
24
Install the Device
Hide quick links:
Advertisement
Table of Contents
