Omron EJ1N-TC4 Operation Manual page 7

End Unit/EJ1C-EDU
■ Ratings
Power supply voltage
Operating voltage range
Auxiliary output Outputs
(See note.)
Transistor outputs
Ambient temperature range
Ambient humidity range
Note: Auxiliary output can be allocated using the bus output allocation for each Basic Unit.
■ Characteristics
Insulation resistance
Dielectric strength
Vibration resistance
Shock resistance
Weight
Degree of protection
Standards Approved standards
Conformed standards
EMC Directive
■ Communications
Port B (See note 1.)
Port A
Port A connector (See note 2.)
Note: 1. Port B communications for the End Unit cannot be used when port C communications for the HFU is used.
2. Port A connector communications and port A terminal communications cannot be used at the same time.
24 VDC
85% to 110% of rated voltage
2
Max. operating voltage: 30 VDC, Max. load current: 50 mA
Operating: − 10°C to 55°C
− 25°C to 65°C (with no icing or condensation)
Storage:
Operating: 25% to 85% (with no condensation)
20 M Ω min. (at 500 VDC)
600 VAC, 50/60 Hz for 1 min between current-carrying terminals of different polarity
2
10 to 55 Hz, 20 m/s for 2 hours each in X, Y, and Z directions
2
150 m/s max., 3 times each in 6 directions
70 g
End Unit case: IP20, Terminal section: IP00
UL61010C-1, CSA C22.2 No.1010-1
EN61010-1 (IEC61010-1): Pollution level 2, overvoltage category II
Same as for the Basic Unit. Refer to page 3.
Basic Unit Communications (Refer to Communications Specifications on page 4.)
Basic Unit Communications (Refer to Communications Specifications on page 4.)
E58-CIFQ1
Modular Temperature Controller
EJ1
7