Omron EJ1N-TC4 Operation Manual page 23

Removing the Terminal Block
1. Press down the terminal block lever.
2. Pull out the terminal block.
Mounting to the DIN Rail
Mounting
Catch the hook located on the top of the Unit onto the DIN Rail and
press the Unit until the Unit locks into place.
(2) Catch the upper hook
onto the DIN Rail.
(3) Press in
on the
(1) Lower the hooks.
Unit.
Refer to the following manual for precautionary information and other information necessary to use the EJ1:
EJ1 Modular Temperature Controller Operation Manual (Cat. No. H142)
Lower the lever.
Pull out.
(4) Make sure the Unit
is locked into place.
Dismounting
Pull down on the hook with a flat-blade screwdriver and lift up on the
Unit.
Flat-blade Screwdriver
Mount one End Plate to each side of the EJ1C-EDU (PFP-M End
Plates are included with the End Unit).
PFP-M
Install the DIN Rail vertically to the ground.
Correct
Vertically
Applicable DIN Rail (sold separately): PFP-100N (100 cm),
Connecting to the G3ZA (EJ1N-TC)
CN1
READY
SD/RD
OCC
CN1
ERROR
Connect the G3ZA
Connecting Cable to the
CN1 connector on the
bottom of the TC Unit.
Refer to the "G3ZA Instruction Manual" for wiring methods.
Modular Temperature Controller
Incorrect
Horizontally
PFP-50N (50 cm)
SW1
SW2
G3ZA
Connect the black line with a
white stripe to terminal 7 on the
G3ZA and the black line with no
stripe to terminal 8.
EJ1C-CBLA050 (Sold Separately)
(cable length: 5 m)
EJ1
23