Wired Network Connections - Yamaha ATS-4080 Owner's Manual

▪ Some security software installed on your computer, or network device settings
(such as a firewall), may block the unit's access to your computer or Internet radio
stations. Should this occur, change security software and/or network device
settings.
▪ A network connection cannot be established if the MAC address filter on your
router is enabled. Check your router's settings.
▪ To configure your router's subnet mask manually, apply the same subnet used by
this unit to all devices.
▪ Use of a broadband connection is recommended when using Internet services.
▪ The unit cannot be connected to a network that requires manual setup. Connect
the unit to a DHCP enabled router.

Wired network connections

To use a wired network connection, connect the unit to a router via
an STP network cable (category 5 or higher straight cable; sold
separately).
Internet
Modem
Router
Mobile device
NOTE
If network connections or settings are changed, use the MusicCast CONTROLLER
app to connect the unit to a network and register the unit as a MusicCast-enabled
device again (p.23).
22
En
Network Attached Storage
(NAS)
WAN
LAN
Computer
Network cable