Connecting To A Network; Wired Network Connections - Yamaha YSP-2700 Owner's Manual

1 2 3 4 5 6
d Connecting to a network

Wired network connections

To use a wired network connection, connect the unit to a router via an STP network
cable (category 5 or higher straight cable; not supplied).
Internet
WAN
LAN
Modem
Router
Mobile device
• If the unit is already connected to a wireless network and you would like to switch to a wired connection,
change "Network" in the setup menu to "Wired".
Network Attached Storage
(NAS)
PC
Network cable
NETWORK
HDMI
INTELLIBEAM SYSTEM SUBWOOFER
OUT (ARC) IN 1 IN 2 IN 3
MIC CONNECTOR OUT R AUX1 L AUX2 TV NETWORK UPDATE ONLY
The unit (rear)
Wireless network
To connect to a network, be sure that the unit is plugged into an AC wall outlet, and
then connect the unit to a wireless router (access point).
Refer to the following for instructions on connecting to a wireless router (access
point).
• Using the MusicCast CONTROLLER app (p. 50)
• Using connection methods other than the MusicCast CONTROLLER app (p. 53 to
59)
Internet
Modem
Mobile device
The indicator on the front panel glows when the unit is
connected to a wireless network.
• You cannot use the wireless network connection simultaneously with the
wired network connection or Wireless Direct (p. 60).
• If the unit and the wireless router (access point) are too far apart, the unit may not connect to a wireless
router (access point). In such case, place them close to each other.
• If the unit will not be connected to a wireless router (access point), Wireless Direct (p. 60) can be used
to connect the unit directly to a mobile device to control the unit using the MusicCast CONTROLLER
app installed on that mobile device.
PREPARATIONS ➤ d Connecting to a network
Wireless router
(access point)
The unit
Glows (green)
27
En