Information For Qualified Contractors Or Dealers; Mounting The Center Unit On A Wall - Yamaha ATS-4080 Owner's Manual

Information for qualified contractors or dealers

Mounting the center unit on a wall

Mount the center unit on a wall using the screw holes on the rear
panel.
CAUTION
▪ To prevent the center unit from falling, attach it to a wall constructed of drywall
(plasterboard).
▪ Make sure you use screws (sold separately) that can support the weight of the
installation. Using clamps other than specified screws, such as short screws,
nails, and two-sided tape, may cause the center unit to fall.
▪ Fix the cables in place where they will not become loose. If your foot or hand
accidentally gets caught on a loose cable, the center unit may fall.
▪ Do not lean on the unit or apply excessive force to the top of the center unit.
Doing so may cause the center unit to fall.
▪ Check that the center unit is fixed securely after the installation. Yamaha will
bear no responsibility for any accidents caused by improper installations.
1
Attach the mounting template (supplied) on a wall
and mark for the screw holes.
DRILL HERE / PERCER CIC
Tapes or thumbtacks
2
Remove the mounting template from the wall, and
then install screws (sold separately) at the points
marked on the wall.
7 to 9 mm
(1/4" to 3/8")
68
En
Mounting template (supplied)
DRILL HERE / PERCER CIC
MOUNTING TEMPLATE / GABARIT DE FIXATION
Screw holes
457 mm
(18")
4 to 5 mm
(#8 to #10)
20 mm (3/4")
13 to 15 mm or more
(1/2" to 5/8")