Initializing The Unit; Connecting To A Network Using The Wac Function - Yamaha ATS-4080 Owner's Manual

3
Within 30 seconds, press and hold the PAIRING
button on the rear panel of the subwoofer at least
three seconds.
Once the center unit and subwoofer have been paired
and a wireless connection established, the * indicator
will glow, and the center unit and subwoofer turn on.
If the * indicator on the subwoofer does not glow after following the
procedure described here, see "No sound is coming from the
subwoofer" (p.56).
* indicator
PAIRING button

Initializing the unit

Reset the settings of the unit to the factory presets.
1
Turn off the unit.
2
Touch and hold | and z/CONNECT on the unit
until all indicators flash.
Connecting to a network using the WAC
function
When the unit is turned on for the first time after purchase, the *
indicator on the center unit flashes slowly. While the * indicator is
flashing, network settings from your iOS device (an iPhone, etc.)
can be applied to the unit to connect the unit to a wireless network
(WAC function).
NOTE
The * indicator does not flash if the unit's NETWORK jack is connected to a router
using a cable (wired connection).
50
En
Flash (initialized)