Table of Contents
Advertisement
Available languages
Available languages
4 Connection
1) Insert the antennas (1) provided into the an-
tenna jacks (12) and put them in a vertical
position
Hint: To increase the range and the interference
resistance, use antenna amplifiers from JTS (e g
UB-900I) The amplifiers are supplied with power
via the antenna jacks of the receiver
2) To connect the subsequent unit, e g mixer
or amplifier, two audio outputs are available:
– XLR output (11): balanced output for con-
nection to a microphone input (when the
20 dB level attenuation has been activated,
chapter 6 5) or to a line input
☞
– 6 3 mm jack (10): unbalanced output for
connection to a line input
3) For power supply, connect the power supply
unit provided to the power supply jack (9)
and to a mains socket (230 V / 50 Hz) The
receiver is provided with a hook for strain
relief (8): Lead the cable around the hook
to prevent accidental disconnection of the
power supply unit from the receiver
Note: The power supply unit will still consume
power when the receiver has been switched off
Therefore, always disconnect the power supply
unit if the transmission system is not operated for
a longer period of time
5 Switching on /off
To switch on, press the button POWER (7) briefly
To switch off, keep the button POWER pressed
until the display indicates
6 Settings
Use the buttons SET
tings for the receiver:
1) To call up the setting mode, keep the
button SET pressed for 3 seconds: The dis-
play indicates
selected ("GROUP" or "FREQ", whichever
function was used to set the current trans-
mission frequency)
2) To select a function, use the button SET:
Press the button repeatedly until the desired
function is reached
3) To change the setting, use the button
or
When a function offers two setting
and
(6) to make set-
and the first function is
options (e g group number and channel
number), use the button SET to go from the
first option to the second option
4) To save the setting, press the button SET
The display indicates
mode is exited
If no setting has been changed when the last
function is reached, the setting mode will be
exited when the button SET is pressed (indica-
tion
)
For detailed information on the functions refer
to the following chapters
6.1 Function "GROUP":
Selecting a frequency from a group
When this function is selected,
ing on the display
The function „GROUP" can be used to select the
transmission frequency from a group of preset
frequencies (channels) Six groups are available;
the number of channels in each group varies:
refer to the table on page 3
This function is suggested when multiple
audio transmission systems are operated at the
same time: For each system, a different channel
can be selected from the same group In ideal
conditions, all channels from a group can be
used at the same time without mutual inter-
ference
1) The letter "G" starts flashing on the display:
Use the button
2) Press the button SET
3) The letters "CH" start flashing on the display:
Use the button
4) To save the setting, press the button SET
6.2 Function "FREQ":
Setting the frequency directly
When this function is selected,
ing on the display
The function "FREQ" can be used to select the
desired frequency from 1441 available frequen-
cies
1) The first three digits of the transmission fre-
quency start flashing on the display: Use the
button
or
of 1 MHz
and the setting
starts flash-
or
to select the group
or
to select the channel
starts flash-
to set the frequency in steps
11
Advertisement
Chapters
Table of Contents
