usi ARL-PRO-2700 Owner's Manual page 16

6. General Operating Tips...
 Read the instruction manual before operating your laminator.
 This laminator has been designed expressly to use USI and ProMount supplies. This
machine has not been tested with any other materials and is not recommended for use
with supplies other than USI and ProMount.
 Always run test samples before laminating valuable items.
 Feed the print through slowly and evenly, smoothing it or using gentle "back pressure" as
it is pulled into the laminator.
 If encapsulating, operate the laminator with two rolls of the same width laminating film to
avoid excessive adhesive transfer to the rollers.
 If laminator is not in current use, turn the machine "OFF."
 Never feed abrasive materials or metal objects such as staples or paper clips through the
laminator. Keep sharp objects like scissors and rulers away from the rollers at all times.
 Once an item has been fed between the Rubber Rollers, do not attempt to alter its
position as this can damage the print.
 Do not stop the laminator before the item has completely exited from the rear to avoid a
"dwell line" across the print.
 Do not service the laminator before disconnecting the power supply.