Kemppi FastMig MR 200 Operating Manual page 11

Restore Factory
Settings
Setup-parameters for MMA welding
Name of parameter
Start Power
Device Address
Code Entry
Restore Factory
Settings
© Kemppi Oy / 1515
FAC OFF, PAn, OFF
ALL
Name on Parameter
display values
StA -9 ... +9
Add 3 or 6
Cod ---, Ent
FAC OFF, PAn, ALL
Control panel reset function.
OFF = No reset
PAn = Settings will be restored, but memory channels
remain unchanged
ALL = All settings will be restored to factory values.
Factory
Description
setting
0 Strength of start pulse
3 Wire feeder bus address
Entering license codes manually:
1. Adjust right potentiometer to ('Ent').
2. Press REMOTE.
3. Set code with right potentiometer.
---
4. Choose next with left potentiometer.
5. Go back to point 3, until all codes have
been set.
6. Approve by pressing REMOTE. ('Suc cEs')
Control panel reset function.
OFF = No reset
PAn = Settings will be restored, but
OFF
memory channels remain unchanged
ALL = All settings will be restored to
factory values
EN
9