Table of Contents
Advertisement
8. Have a second person hold the Console (75)
near the Neck (76).
Plug the Neck Wire (108) into the receptacle on
the back of the Console (75). The connector
on the Neck Wire should slide easily into the
receptacle and snap into place. If a connector
does not slide easily into a receptacle, turn the
connector and try again. If you do not connect
the connector properly, the Console may
become damaged when you use the rower.
Insert the excess wire into the Neck (76) or into
the Console (75).
Tip: Avoid pinching the Neck Wire (108). If
necessary, tilt the Neck (76) upward to make
this step easier. Attach the Console (75) to the
Neck with four M4 x 19mm Screws (69); start all
the Screws, and then tighten them.
9. Attach the Tablet Holder (111) to the Console
(75) with four Tablet Holder Screws (112); start
all the Tablet Holder Screws, and then tighten
them.
Then, plug the Power Adapter (109) into the
receptacle on the frame of the rower.
Note: To plug the Power Adapter (109) into an
outlet, see HOW TO PLUG IN THE POWER
ADAPTER on page 10.
10. Make sure that all parts are properly tightened before you use the rower. Extra parts may be included.
Place a mat under the rower to protect the floor.
8
75
108
9
75
9
Avoid
pinching
the wires
76
69
69
111
112
109
Hide quick links:
Advertisement
Table of Contents
