Advertisement
Step 5
- Insert gas-sampling
probe into stack
CAUTION:
Water trap level should be monitored and
emptied to avoid damage that is possible
when moisture is pumped into analyzer
P
Flue Gas Measuring Mode Displayed
Flue gas
Nat gas
7 5 . 7
Tstack
1 . 1 4
8 8 . 2
8 0 3 . 0
ExAir
Fuel
Start
fig 6
F Scroll though line items
(press
/
)
F Orange hot keys can be used to:
- change fuel (Fuel)
- start measuring flue gasses
(Start)
Reminder:
Probe must be inserted into
stack to take stack measurements
F Orange hot keys can be used to:
- print real time measurements
- lock in measurements (Stop)
Reminder:
This assumes you pressed the START
button on the previous screen
Step 6
- Print locked-in data
P
Flue Gas Measuring Mode Displayed
Flue gas
Nat gas
(fig. 6)
7 5 . 7
1 . 1 4
8 8 . 2
8 0 3 . 0
°F
Print
Start
%
fig 7
CO2
%
EFF
F Orange hot keys can be used to:
%
- print locked-in measurements
(Print)
- Start a new test (Start)
Reminder:
This assumes you pressed the STOP
button on the previous screen
CAUTION:
Pressing Start again will write over
locked-in data from previous real-time
flue gas measurements.
Items NOT to be written over are:
Draft
CO-AirFree
- When stored independent
measurement
Smoke/Oil
Diff prs
Delta Temp
Ambient CO
Step 7
- Turn OFF instrument
Analyzer will enter a purge mode from 1-90 seconds based on last O2 measurement
taken then cycle off
(fig. 7)
CAUTION:
All locked-in and saved date will be deleted
°F
Tstack
%
CO2
Step 8
- Care for your analyzer
%
EFF
%
ExAir
A
Empty water trap daily (minimum) or when it appears to be full (see figure 8)
A
Disconnect probe from the instrument during storage of the analyzer wile not in use
A
Replace the particle filter when visibly dirty (see fig. 9)
fig 8
Please read, undersand and follow the directions, pre-cautions
and warnings in the product instruction manual.
testo, Inc. 35 Ironia Rd., Flanders, NJ 07836, 800-227-0729, fax 973-252-1729,
fig 9
www.testo.us. e-mail: info@testo.com
August, 2007
Advertisement
