Cisco D9800 Configuration Manual page 6

Configuring the ASI or MPEGoIP Output Mode
Option
SPTS Service Channels Only
(MPEG over IP only)
SPTS MAP Service Channels
Only (MPEG over IP only)
SPTS Transcoding
(multi-stream units only)
You are prompted to Resync All for the selected output. This resynchronizes the inputs to outputs for the current PMT
according to the service assignments and the PIDs for the PE.
The Mode Status field, or the Config Type front panel menu, indicates the current DPM configuration change by a user
after changing the Output Mode. The following table lists the statuses:
Mode Status or Config Type
Unmodified
Edited by User
Auto Re-Mapped
Chg by Uplink
Cisco D9800 Network Transport Receiver Version 3.01 Installation and Configuration Guide
6
Description
The service channel is passed with the same channel number, PMT PIDs, and ES PIDs.
The service channel is mapped to the preconfigured channel number, PMT PIDs, and
ES PIDs.
The service channel is mapped to the preconfigured channel number, PMT PIDs, and
ES PIDs. The PEs are automatically set to XCode.
Description
No changes were made after setting a new output mode.
In a multi-stream unit, this applies to single input mode only. For
more information on single input mode, see
to a Program
In a multi input mode, Unmodified (MS Mode) status is displayed.
DPM changes were made by the user after setting the Output Mode.
In a multi-stream unit, this applies to a single input mode only. For
more information on the single input mode, see
to a Program
In a multi input mode, Edited by User (MS Mode) status is
displayed.
The output map changed automatically to fix the output channel or
PID conflicts at the time of setup.
In a multi-stream unit, this applies to a single input mode only. For
more information on the single input mode, see
to a Program
In a multi input mode, Auto re-mapped (MS Mode) status is
displayed.
DPM output changes were made, based on the uplink request after
setting the Output Mode.
In a multi-stream unit, this applies to a single input mode only. For
more information on the single input mode, see
to a Program
In a multi input mode, Chg by Unplink (MS Mode) status is
displayed.
Configuring the Transport Stream Information
Entry.
Entry.
Entry.
Entry.
Assigning a Channel
Assigning a Channel
Assigning a Channel
Assigning a Channel