Cisco D9800 Configuration Manual page 19

Configuring the Transport Stream Information
Configuring Auxiliary Program Entries
You can only configure auxiliary program entries on a multi-stream unit.
Step 1
Ensure that the Enable Auto Map For Auxiliary PEs drop-down list is set to Yes. For more information, see
up the Auto Synchronization Options, on page
Step 2 From the D9800 web GUI, choose Transport Stream > Digital Program Mapping for ASI 1, ASI 2, IP Data 1/Data
2, or IP Data 3/Data 4. Or, from the D9800 front panel, choose Setup > Outputs > TS Out > DPM > ASI1, ASI2,
IP1/2, or IP3/4.
Step 3 Click a PxA to edit or choose a PxA from the PE front panel menu.
Step 4
Choose Map from the Action drop-down list, or the Act front panel menu. For more information on the Action parameter,
see Configuring the Program Entries, on page
Step 5 Save your changes.
Step 6
Click Resynchronize All or choose Resync: All front panel menu to ensure that the inputs and outputs are the same.
Mapping the Program PIDs
The PID mapping feature allows you to map input services to output PIDs. If the PE Action is Pass, or the
PE Action is Map and the Remapping Mode is set to Svc ID, only entries which drop a service are applied
and all other services are passed through. If the PE action is Map and Map Mode is Svc ID & PID, all entries
are applied. Any services not mapped by an entry will be dropped.
For the front panel, press up and down to scroll through the PID map entries. Press ADV to insert or delete
entries from the PID map. After inserting an entry, specify the service using OutType and In, and set the
desired Action. If the action is Map, select the output PID value as well. Then press APPLY and save the
settings to see the selected input service that will follow that mapping.
Step 1
Do one of the following:
• Web GUI (single-stream unit): From the D9800 web GUI, choose Transport Stream > Digital Program Mapping
for ASI or MPEG over IP output.
• Front Panel (single-stream unit): From the D9800 front panel, choose Setup > Outputs > TS Out > DPM > ASI
or MOIP.
• Web GUI (multi-stream unit): From the D9800 web GUI, choose Transport Stream > Digital Program Mapping
for ASI 1 Output, ASI 2 Output, IP Data 1/Data 2 Output, or IP Data 3/Data 4 Output.
11.
17.
Cisco D9800 Network Transport Receiver Version 3.01 Installation and Configuration Guide
Configuring Auxiliary Program Entries
Setting
19