Cisco D9800 Configuration Manual page 27

Configuring the Transport Stream Information
Option
Auto
SD Output
HD Output
Step 4 Apply your changes.
The Remaining HD Transcoders field displays the remaining HD licenses available to transcode on the unit. The
number of resources available is updated automatically when you choose the transcoder output. Choosing Auto or HD
Output decreases the HD license count by one.
Setting up Transcoding
This is for multi-stream units only (D9800-MS-MPEGOIP).
Step 1
Verify that you are receiving a valid signal and that you have set up the channels that you want to transcode.
Step 2 Set the ASI and/or IP Data Output Mode to Transcoding. You will be prompted to Resync All for the selected output.
This resynchronizes the inputs to outputs for the current PMT according to the service assignments and the PIDs for the
program entry. For more information, see
Step 3 Save your changes. If the changes cannot be saved, an error message is displayed.
When remapping an input program channel to an output program channel, ensure that the PIDs are mapped to
Note
different PIDs to avoid PID collisions.
Step 4 If desired, set a program channel for the second transcoder channel (PE2) and repeat Step 2, depending on the transcoding
licenses. For more information on assigning a program channel to a PE, see
Description
The input video format and resolution remains unchanged during transcoding. For example, if
the input video format is SD, the output video format is also SD.
The video down-converts from HD to SD when an HD input signal is received. The SD horizontal
resolution will follow the SD HRes parameter set in transcoder settings. For more information on
transcoder settings, see Configuring the HD and SD Transcode Settings, on page
The input video up-converts from SD to HD 1080i when receiving an SD input signal. The HD
horizontal resolution will follow the HD HRes parameter, set in transcoder settings. For more
information on transcoder settings, see
28.
Configuring the ASI or MPEGoIP Output Mode, on page
Cisco D9800 Network Transport Receiver Version 3.01 Installation and Configuration Guide
Configuring the HD and SD Transcode Settings, on page
Assigning a Channel to a Program
Setting up Transcoding
28.
4.
Entry.
27