Advertisement
1.- WARNING
Please read these instructions before installing or using this appliance for the first time.
• The warranty of the heater will not cover any damage caused by non observance of any of these
instructions.
• The instructions should be retained for future reference. This guide must be kept and given to
any new owner.
• Please check that the voltage in the rating label fits the power supply.
• Any reinstallation should be carried out by trained personnel.
• The use of these heaters is forbidden in any area where there is a presence of gases, explosives
or inflammable objects.
• DO NOT USE THIS HEATER TO DRY CLOTHES.
• The surfaces of this heater can be hot, so young children should not be left unsupervised in the
vicinity of the heater.
• Children should be supervised to ensure they do not play with the appliance.
• Neither the connecting cable nor any other object must come into contact with the hot unit.
• Do not cover this heater at any time.
• The air outlet at the top of the inertia radiator and the air inlet at the bottom are provided to
ensure the most efficient operation of the appliance. They also protect the heater from
overheating; therefore, it is essential that at no time are they covered.
• This heater should be switched off at the isolating switch before any repair work is carried out.
• This appliance should not be installed just below an electrical socket.
• This appliance must be installed in such a way that it is impossible for anyone using a bath or
shower, to touch the controls.
• The installation must be carried out in accordance with the current electrical regulations.
• The heater is fitted with a flexible cable size 3 x 1.00 mm² for electrical connection. It may be
used to connect the heater to the fixed wiring of the premised through a suitable connection box
positioned adjacent to the heater.
• The supply circuit to the heater must incorporate a double pole isolating switch having a contact
separation of at least 3 mm.
• If the flexible power cable for this unit is damaged, it may only be replaced by a repair workshop
recognised by the manufacturer, as special tools are necessary.
• This appliance is not intended for use by persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety.
• This appliance must be earthed.
• All models are supplied with an electrical interrupt cut-out. This will switch off the heater if, for
any reason, it overheats. Should the cut-out operate, turn the heater off and remove the cause
for the overheating. The cut-out will be reset automatically.
• The presence of air particles of smoke, dust and other pollutants could, in time, discolour the
walls and surfaces around the heater.
MODELS
MODULES
W (cm)
D (cm)
H (cm)
WEIGHT (kg)
VOLTAGE
INPUT (W)
INSTALLATION INSTRUCTIONS
RX6ELST
RX10ELST
6
57.5
10 + 2 cm separated from the wall
13,5
220-240V~
775
2
RX12ELST
10
12
89.5
105.5
58
21,5
25,5
1300
1550
Advertisement
