Quick Wizard: Capacities (Energy Metering); Space Heating Control - Daikin Altherma EHVH08S18CBV Installation Manual

5 Configuration
# Code
[A.2.2.5] [C-06] External room thermostat for the
additional zone:
▪ 0: N/A
▪ 1 (Thermo ON/OFF): When the used
external
heat pump convector can only send a
thermo ON/OFF condition.
▪ 2 (H/C request): Because only heating
is possible, the used external room
thermostat can only send a thermo
ON/OFF condition.
[A.2.2.B] [C-08] External sensor:
▪ 0 (No): NOT installed.
▪ 1 (Outdoor sensor): Connected to
PCB
temperature.
▪ 2 (Room sensor): Connected to PCB
measuring the indoor temperature.
Digital I/O PCB
# Code
[A.2.2.6.1] [C-02] External backup heater source:
▪ 0 (No): None
▪ 1 (Bivalent): Gas, oil boiler
▪ 2: N/A
▪ 3: N/A
[A.2.2.6.2] [D-07] Solar pump station kit:
▪ 0 (No): NOT installed
▪ 1 (Yes): Installed
[A.2.2.6.3] [C-09] Alarm output on optional EKRP1HB
PCB:
▪ 0 (Normally open): The alarm output
will be powered when an alarm
occurs. By setting this value, a
distinction is made between the
detection of an alarm, and the
detection of a power failure.
▪ 1 (Normally closed): The alarm
output will NOT be powered when an
alarm occurs.
See also table below (Alarm output
logic).
[A.2.2.6.4] [F-04] Bottom plate heater
▪ 0 (No): NOT installed
▪ 1 (Yes): Installed
Alarm output logic
[C-09] Alarm
0 (default) Closed output
1 Open output
Installation manual
14
Description
room thermostat or
measuring the outdoor
Description
No alarm No power
supply to unit
Open output Open output
Closed output
Demand PCB
# Code
[A.2.2.7] [D-04] Demand PCB
Only applicable for EHVH04+08.
Indicates if the optional demand PCB is
installed.
▪ 0 (No)
▪ 1 (Pwr consmp ctrl)
Energy metering
# Code
[A.2.2.8] [D‑08] Optional external kWh meter 1:
▪ 0 (No): NOT installed
▪ 1: Installed (0.1 pulse/kWh)
▪ 2: Installed (1 pulse/kWh)
▪ 3: Installed (10 pulse/kWh)
▪ 4: Installed (100 pulse/kWh)
▪ 5: Installed (1000 pulse/kWh)
[A.2.2.9] [D‑09] Optional external kWh meter 2:
▪ 0 (No): NOT installed
▪ 1: Installed (0.1 pulse/kWh)
▪ 2: Installed (1 pulse/kWh)
▪ 3: Installed (10 pulse/kWh)
▪ 4: Installed (100 pulse/kWh)
▪ 5: Installed (1000 pulse/kWh)
5.2.4 Quick wizard: Capacities (energy
metering)
# Code
[A.2.3.1] [6-02] Anti-legionella heater capacity [kW]
[A.2.3.6] [6-07] Bottom plate heater capacity [W]
5.2.5

Space heating control

Leaving water temperature: Main zone
# Code
[A.3.1.1.1] N/A Set point mode:
▪ 0 (Fixed): Absolute
▪ 1
dependent
▪ 2
scheduled (only for leaving water
temperature control)
▪ 3
dependent + scheduled (only for
leaving water temperature control)
EHVH04+08S18CBV + EHVH08~16S26CBV
Description
Description
Description
Description
(Weather dep.): Weather-
(Fixed/scheduled): Absolute
(WD/scheduled): Weather-
Daikin Altherma – Low temperature split
4P449977-1B – 2018.02
+