Eaton EG2-NA Installation Manual
Eaton EG2-NA Installation Manual

Eaton EG2-NA Installation Manual

Ethernet gateway

Advertisement

Installation guide
Eaton Lighting Systems
EG2-NA
Ethernet Gateway

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EG2-NA and is the answer not in the manual?

Questions and answers

Summary of Contents for Eaton EG2-NA

  • Page 1 Installation guide Eaton Lighting Systems EG2-NA Ethernet Gateway...
  • Page 2: Table Of Contents

    Control Wiring Setup Instructions Please Read This First The EG2-NA is built and tested to strict safety regulations. By following the steps listed below and elsewhere within this guide, you can ensure safe installation and operation of these controller units.
  • Page 3: Introduction

    Ethernet connection: Fully transformer isolated router. Ambient temperature range: 0°C to 40°C (32°F to 104°F) The EG2-NA acts as a host for the iLumin or Humidity: 20% to 90% non-condensing iLight series of remote applications including iOS (iPhone/iPod Touch/iPad & Android OS Configuration and sequence memory devices).
  • Page 4: Product Overview

    Product Overview Mounting Location and spacing The EG2-NA should be installed in a dry ventilated location, where ambient conditions are maintained within the requirements of the unit. The unit has ventilation slots on its sides to allow convection cooling and under no circumstances should these be blocked.
  • Page 5: Supply Wiring

    A removable 5 position terminal block is provided for the connection of iCAN network This unit requires a 120-240 VAC single phase cables. If the EG2-NA is located in the middle supply (live and neutral) with 0.45 A capability. of the network, incoming and outgoing cables will terminate within the same connector.
  • Page 6: Setup Instructions

    Wait for the Green CAN LED to flash slowly. Ethernet Switch or Wireless Router. The Green Power LED will double flash continuously while EG2-NA is on. If Ethernet is connected the Link and Data LEDs will indicate Ethernet Input successful connection.
  • Page 7: Reset To Factory Defaults

    IP address. For details of setting the IP address of your computer consult information online specific to your Operating System. If the EG2-NA you are configuring is at the factory default settings, the following settings are suggested when assigning a static IP...
  • Page 8 TechSupportCC@eaton.com www.eaton.com/lighting All products manufactured by Eaton Lighting Systems and identified with the iLight or iLumin product series mark are warranted to be free from defects in material and workmanship and shall conform to and perform in accordance with Seller’s written specifications.

Table of Contents