Advertisement

Quick Links

Installation guide
EG-2
Ethernet Gateway

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EG-2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Eaton EG-2

  • Page 1 Installation guide EG-2 Ethernet Gateway...
  • Page 2: Table Of Contents

    Contents Introduction Basic Schematic Installation Product Overview Connecting the Supply iCAN Network Connections Set Up Instructions Configuration Setting the IP address Eaton Lighting Systems iLight Product Series - EG-2 9850-000224-02...
  • Page 3: Introduction

    Facilities are provided to allow a BMS or Dimensions smart home system to interact with the iLight network. This is achieved by simple character strings communicated via a UDP or TCP connection. Basic Schematic Eaton Lighting Systems iLight Product Series - EG-2 9850-000224-02...
  • Page 4: Product Overview

    CAN Termination Switch that causes the EG2 to End of network send a message on the CAN termination jumper. BUS to identify itself iCAN status Green flashing LED indicates normal operation Eaton Lighting Systems iLight Product Series - EG-2 9850-000224-02...
  • Page 5: Connecting The Supply

    Device T - Indicates where a termination is required. The EG-2 has built-in network termination. If the EG-2 is at the end of the network, ensure the CAN TERMINATION jumper is fitted in the iCAN Network Connections Termination On position.
  • Page 6: Set Up Instructions

    Node. Search the network and load the EG2 into the software. Go the Ethernet tab. Either the Default settings can be applied or other settings can be applied. Select OK or Apply to download the changes to the EG2. Eaton Lighting Systems iLight Product Series - EG-2 9850-000224-02...
  • Page 7: Setting The Ip Address

    Press the CAN ID button and reapply power. Keep the button pressed until the CAN LED flashes then stays on. At this point the Ethernet settings will have been restored to defaults. After setting to factory defaults, the IP address of the device will revert to 192.168.0.100 Eaton Lighting Systems iLight Product Series - EG-2 9850-000224-02...
  • Page 8 Email: TechSupportCC@eaton.com Web: www.iLight.co.uk All products manufactured by Eaton Lighting Systems and identified with the iLight product series mark are warranted to be free from defects in material and workmanship and shall conform to and perform in accordance with Seller’s written specifications.

Table of Contents