Setting Up The Aed - Defibtech DDU-2300 Operating Manual

SETTING UP THE AED

The DDU-2000 Series AED is designed to be stored in a "ready"
state so that few steps are required to begin using the AED.
CONNECT
THE PADS TO
THE AED
1
Ensure that the pads package has not
expired. Expired pads must not be used.
For more information, refer to page 15.
INSTALL THE
BATTERY PACK
2
Ensure that the battery pack has not expired.
Expired battery packs must not be used.
When the battery pack is installed, the AED will turn
on and run a battery pack test. Wait for the test to
complete and for the unit to turn off.
For more information, refer to page 16.
8
DAC-A2530EN-BK
AED status
Battery status
CHECK THE
Pads status
STATUS
AED S/N
Battery S/N
3
Software version
AED Status screen
For more information, refer to page 18.
READ THE
USER MANUAL
(at www.defi btech.com)
4
Comprehensive information about the
DDU-2000 Series AED can be found in the
User Manual (at www.defi btech.com).
For more detailed information, refer to the User Manual (at www.defi btech.com).
With the AED off,
press and release the
OK
CENTER softkey button.
Ensure that the AED
Expires 01/20xx
Status screen appears
Adult
Expires 06/20xx
and that the "AED
099999999
099999999
Status" is "OK" .
Vx.x
AND
When the AED is off, the
Active Status Indicator (ASI)
should fl ash green. If the ASI
fl ashes red, is solid red, or if
there is no fl ashing light, the
unit requires service.
DAC-A2530EN-BK
9