Test Hsm2Host Location For Rf Interference; Permanently Mount; Other Options - DSC HSM2HOST8 Installation Manual

H S M 2 H O S T I n s t a l l a t i o n M a n u a l

1.1.6 Test HSM2HOST Location for RF Interference

The HSM2HOST performs best in locations where RF interference is minimal. To find a suitable mounting location:
• With the alarm panel powered up and the HSM2HOST enrolled, enter installer programming section [904]. Observe the status of the red LED.
If the red LED is on, interference levels are high and a new mounting location should be found. If the red LED is off, interference is low
and the location is good.
NOTE: For UL/ULC listed systems, signal must be "Strong". See Table 2-9 Wireless Device Status Indications on page 7 for details.

1.1.7 Permanently Mount

Once a suitable location is found, mount the HSM2HOST as follows:
1. Pull the Corbus wires through the holes at the back of the
2. Mount the cabinet securely to the wall using the supplied 3 (three) screws.
Figure: 3 Mounting the HSM2HOST
4. To enable the wall tamper, fasten the breakaway wall tamper bracket securely to the wall using the supplied screw.

1.1.8 Other Options

The following actions may be performed on the HSM2HOST.
Section
[902] > [106] Delete the HSM2HOST from the alarm system.
[903] > [106] Confirm that the HSM2HOST is enrolled.
[000] > [806] Add a label to appear on LCD keypads.
[900] > [461] View HSM2HOST model information.
cabinet.
Action
3
S e t u p & W i r i n g